Electric layout and combing study

COMMET Group has its own research department specializing in the design of solutions adapted to the theoretical or real drawings after measurements we may have made on the work site in HV cable galleries or substations.

Our research department’s engineers and technicians integrate the requirements of the project as well as its setting up constraints, while complying to the RST recommendations established by the CNER (National Network Expertise Center) of RTE (French electricity transmission system operator).

Thanks to 3D views and VR (virtual reality) equipment, COMMET group's project teams can move in the digital environment and check every important technical aspect (pathways, interfaces, laying, etc.)

Each work site (substation, gallery) has its own technical constraints:

Footprint and available room
Traffic constraint
Laying constraint
Quantity and characteristics of lines (spacing between supports, linear mass, diameter, etc.)
Combing constraints (radius of curvature, distance between elements, etc.)
Access to the work site and characteristics (temperature, humid/submersible environment, etc.)
Fireproofing requirements (anti-common mode, protection of MV/HV/EHV lines)

COMMET Group’s research department can take these constraints into account and conduct the necessary studies beforehand to define and validate technically and economically possible solutions while complying with regulatory or specific requirements, as described by RTE:

Study and combing drawing proposal
Diagram of the installation with 3D view of the setup
Complete drawing of the installations with the addition of COMMET products presented in the catalog
Assembly process and digital simulation